KitLog pro

Powered By Kitlog Pro v2.0

Zenith CruZer & Sonex Logs
' style=
Date:  12-31-2018
Number of Hours:  1.00
Manual Reference:  C75-FA-4
Brief Description:  Fwd Fuse Alignment

Not a lot of work accomplished, but got over a mental block on finishing these sides.

Removed the sliding seat supports (front & rear) and trimmed the ends where they were preventing the side panel from sliding all the way in place.

Cleco'd the side in place (lots more had to be un-done!), then started adding the seat supports etc back in place.

I was a bit concerned yesterday when trying this because it wasn't clear whether the supporting L-angles (pre-made in this case affixed to the front or aft of the vertical side panel angles. It all makes sense now and is actually a bit easier the way that Zenith designed it.

Spent a lot of time clamping the side in place and ensuring the fuse bottom skin was level. I need a clamp my son borrowed, so stopped for the evening.
' style=

Clamped to check level

Clamped to check level

' style=

holes in parts pre-drilled

holes in parts pre-drilled

' style=










Copyright © 2001-2020 Matronics. All Rights Reserved.