Brief Description: Finished edge deburring skins, on to holes
Started today by CSKing the rudder stop and tie-down AEX to accect the dimples in the 1012A bulkhead. I then CSK'd the longerons and did a little more clean-up. It was time, then, to tackle the skins. I got all 5 (the bottom, L & R sides, and foward & aft top skins) edges deburred and started on the bajillion holes. Thank God for my wife's Black and Decker power screw driver. It has a hex drive in which I have inserted my hex extension deburring bit. It is a huge time saver and I can't imagine doing all of this deburring without it.