KitLog pro

Powered By Kitlog Pro v2.0

Swami's Web Site
Work Logs Found: 43
Category Work Time: 92 Hours
 Date
Hours
Work Log Summary

Details

 05-31-2020
0.00
wiring pictures
       

 05-31-2020
0.00
ELT ID / Hex picture
       

 05-31-2020
0.00
ELT equipment pictures
       

 05-03-2020
2.50
Secure right wing AP wires; install aeleron trim h

 04-26-2020
4.50
Secure L wing wires; Re-run right wing wires
Details

 04-21-2020
1.50
Torque all spar bolts; Wings attached complete

 04-21-2020
2.50
fix left OAT wiring; safety wire Pitch AP
Details

 11-30-2019
1.00
Wire OAT sensor in Right wing

 11-29-2019
2.00
Pick up keys to Hanger; wire OAT in Left wing
     

 06-28-2019
2.50
complete and attache wires to aft fuse securements
Details

 06-24-2019
2.00
Install wire securements in aft fuselage
Details

 05-26-2019
3.00
complete wire wrap fwd tunnel
Details
     

 04-21-2019
1.00
start final wire bundle wrap under forward fuse
Details

 01-26-2019
1.50
Rewire diode to "I" and starter Keywire to "S" on
Details

 01-26-2019
3.50
Install aileron trim box and wire.
Details

 01-13-2019
1.00
stick grip switch test- Flap up/down reversed
Details

 01-13-2019
1.00
correct stick flap wiring.test intercom OK
Details

 01-12-2019
4.00
wire 9 pin DSUB for both stick grips
Details

 12-28-2018
3.00
Confirm and attach all ACM harnesses
Details

 12-24-2018
2.00
Wire panel Pwr relay; Battery; Aileron trim/ Fans
Details

 12-15-2018
2.50
Wire strobe +tail + ldg light molex
Details

 11-11-2018
1.00
Install L wing landing light molex
Details

 11-10-2018
4.50
wire seat heat and CO2 monitor to ACM
Details

 10-30-2018
1.00
Complete Rt wing light/strobe molex, fuel sender m
Details

 10-29-2018
2.00
Complete ACM rear harness; Run R wing strobe wire
Details

 10-28-2018
3.50
Completed ACM stick harness; L+r wing light molex
Details

 10-22-2018
2.50
Complete ACM Flap/trim harness; Prep ACM rear/stic
Details

 10-20-2018
2.00
Run Landing light wires to panel; re-run cables
Details

 10-13-2018
5.00
Re-install strobe molex with ground;Pitot+Flap Mol
Details
       

 10-08-2018
1.50
Install Flap motor molex
Details

 10-08-2018
1.50
determined Stobe wire shielding ground
Details

 10-08-2018
5.00
completed cable routing and install
Details

 10-07-2018
1.50
Run fuel/stall wires
Details

 10-07-2018
2.50
Install AMP connects on wing tail wires
Details

 10-06-2018
3.50
Wire bundle path through spar
Details

 10-06-2018
1.00
Stert running wing wires from panel
Details

 10-06-2018
1.00
Run Stick wires, Flap Position wire
Details

 10-06-2018
1.00
install GPS antenna
Details

 10-06-2018
1.50
Install ELT
Details

 09-30-2018
2.00
run,installADS-B, XPDR, Comm wires
Details

 09-30-2018
3.00
AP pitch dsub, fwd center tunnel cover
Details

 09-22-2018
3.00
research and seek tech support AP/PMag/Stick
Details

 09-22-2018
2.00
Flap motor and pitch AP wire routing
Details










Copyright © 2001-2024 Matronics. All Rights Reserved.